SPLENDID PATHS: DESIGN IDEAS FOR HOME GARDENERS
Paths lead you comfortably, safely and by the shortest route from the street to door, from patio to garden, from the garden to the greenhouse, and so forth about your home grounds. With driveways, they comprise your property’s all-important “circulatory system,” curb appeal. It is unwise to proceed with making a garden or remodeling until you’ve determined the location of paths.
Entrance paths lead to the main door of a house and receive continuous heavy traffic. They must be wide (at least 3 1/2 feet) so that two people can walk side by side. Avoid unnecessary curves that slow down the approach to the door. Use durable surfacing materials, which are easy for walking, not slippery when wet and should harmonize with the architecture of the house.
Service paths are those which connect the front yard to the rear service area or link a terrace to a side door or garage. Generally, they receive less traffic than entrance paths, but they too should lead directly from one point to another. Their width and surfacing material are determined by the amount of traffic they will receive. Usually, a 2-foot width is the narrowest they can safely be.
Garden paths are not, for the most part, utilitarian. They receive comparatively little traffic, and because the flowers and shrubs that border them call for attention, persons willingly meander slowly. Great latitude in their design and construction is permissible; however, to give the greatest pleasure, even garden paths must lead somewhere – to a bench, a specimen tree, a group of unusual flowers.
One way to design an efficient “circulatory system” is to observe the tracks people make as they walk around your grounds before the soil is finally graded or to observe the worn areas in an established lawn. Without fail people will reach their destination by the shortest and easiest possible route. Design a path plan for a home property with this thought in mind.
Paths near buildings usually look best if they parallel the building line, and on a rolling site if they follow major contours. Cut diagonally up a gentle slope for easy ascent but go directly up a steep slope, in which case steps are required.